|
IntelliClimate Intelligent Climate & Grow Room Control |
|
|
|
 The IntelliClimate™ is the ideal climate controller for all sizes of grow chamber. It controls temperature, humidity, lights and CO2 in a unified way to obtain the best possible growing climate. It does all this while minimizing waste of CO2 and electricity.
A standard feature of the IntelliClimate is the USB connection to a PC. This provides a new level of user friendliness and allows the grower to easily view and change settings, view readings and look back to see what growing conditions were like during periods when the grow room was unattended. The PC also provides for remote alarms and even text messaging to a mobile phone. With remote access software you can carry out all these functions over the internet or phone connection. Note that the controller will operate fully without a PC connection with the exception of the scheduling feature.
If you want to achieve the best possible growth rates and have the ability to “steer” the crop to a perfect outcome, the IntelliClimate is the grow room controller for you.
With the IntelliClimate you can start small and gradually add to your equipment until you have the most sophisticated system possible, if that is what you desire. If growing in difficult climatic conditions (very hot or very cold) then you will need to start with more sophistication than if you are in a more temperate area.
- Controls lights, fans, dehumidifier, aircon, heater, CO2, humidifier
- Comes standard with USB cable and intuitive PC software
- Built-in failsafes to look after your crop if something goes wrong
- Advanced settings page allow you to fine tune the system
- Scheduling allows you to enter a table of settings for the complete grow
- Alarms on all key variables including intruder alarm
- Alarms can sound on PC or even dial out via modem to your mobile
- Remote access software can be used to view readings and change settings from anywhere in the world (password protected)
- Power supply adapter
The unit is normally supplied with a universal input (100V to 240V 50/60Hz) power adapter which provides the IntelliClimate with a safe, low voltage supply of 24V DC at 2.5 amps
- Outputs
8 outputs that have the same voltage as the supply (normally 24V DC) Ratings of individual outputs are 3 amps. But of course, the total draw from all 8 outputs must not exceed the rating of the supply adapter.
- Inputs
The temperature, RH, Light sensors are all connect on a bus cable. The three wires in the bus cable supply the sensor units with 5VDC power and receive digital data back along the third wire. Maximum length of this bus cable is 20m (60ft). The unit is supplied with one temperature/RH/light sensor box on a 5m (15ft) cable. A second sensor box and an external temperature sensor may be added. These would be connected in daisy chain fashion on the single bus cable.
- Temperature/RH/Light enviro sensors:
Temperature accuracy: +/- 0.5°C
RH accuracy: +/- 3% to 95% then +/-5%
Light accuracy: +/- 5%; Total light 0 to 1000 Joules
CO2 input: 10 bit resolution (1 part in 1000)
- CO2 sensor
0 to 2000 PPM corresponding to 0..10V signal. Connect into one (or both) enviro sensor boxes. A separate 24V power adapter is required for each CO2 sensor. Sensors that have self calibration (ABC logic) must have this disabled for use in a grow room. Calibration should be checked regularly using a high accuracy hand held meter. The supplied sensors should have their calibration checked (and be recalibrated if required) at least once per year.
- 3 x Relay Boxes
The twin relay boxes have a total current capability as follows:-
USA 110V at 15 amp total draw
UK 240V at 12 amp
Australasia 240V at 10 amp
The standard IntelliClimate kit includes the following:
- IntelliClimate controller with USB cable and PC software on CD-ROM
- 3x twin relay boxes (i.e. 6 independent relay controlled socket outlets)
- Environment sensor box that goes into the grow room to measure temperature, humidity and light. You can also connect a CO2 sensor to this box (an optional accessory listed below)
- Magnetic door intruder switch
The following accessories are optional:
- CO2 sensor
- Second environment sensor (gives extra safety if one sensor fails - you have
an automatic backup)
- Outside temperature sensor
|
Choose to Find a Retailer
nearest you, or click on the
Add to Cart button to purchase
it online and have it shipped
from one of our
Preferred Retailers:
|
IntelliClimate Complete |
 |
$1,999.95
|
|
|
|
|
